Home/Everyday/Carpet dents

The tool is ice. An iron melts polypropylene at 165 °C.

Four square dents where the sofa stood · The marks have been there for years · You can feel a hard dish under the flattened patch · The pile comes up if you pick at it · It crumbles between your fingers instead · There is a shiny flat spot where someone ironed it · The dents are in a walkway, not under anything · Fresh carpet in the same room lifted in a day
FreeIce cubes, a towel and a day of not walking there
FreeFurniture cups, to stop it happening again
BoughtA patch, only when the backing has dished
Easy · 5 min of work, a day of waiting · The waiting is the part that does the work

A carpet seen from above with vertical tuft lines and four oval dents where furniture legs stood, and a chair beside it; below left, the pile in section — three crimped yarns on the left and the same yarns crushed flat on the right, with an ice cube above and drops falling into the crushed yarn; below right, the backing in section — flat above, and dished into a bowl below with a patch marked on it

diagnose
What failed
—
Where
—
State
—
Next
—
what to touch fault correct Click the carpet, the pile or the backing

Spring comes from crimped yarn, and water plus time is what lets it come back

Two facts about the material. A carpet's resilience lives in the crimp of its yarn — each tuft is a fibre that was heat-set into a spiral, and the spiral is what pushes back. A leg standing on it for a year flattens the spiral and closes the air gaps between fibres, and the patch goes dead. The backing underneath is a different problem entirely: fabric plus latex or bitumen, and once it has been pressed into a dish it stays dished, because there is no crimp in it to spring back.

That gives the two-second test. Press the dent with your palm and then with your fingertips. If the fibre comes up when you lift it a little, the yarn is there and only flattened — that is treatable. If you feel a hard, smooth, shallow dish with a defined rim, the backing has gone and no treatment will lift it; that dent gets a patch or stays. Everything else on this page follows from which of those two you are feeling.

And the treatment is counter-intuitive in the right way. Ice is the tool, because it gives the two things the fibre needs at once: water and time. As a cube melts it releases water slowly into the crushed tufts; the fibre absorbs it, swells, and its glass transition drops, which is a complicated way of saying the yarn becomes supple enough to unfold. The cold also stiffens it once it has unfolded, so it sets. Twelve to twenty-four hours later the crimp is back and the pile stands up. An iron delivers the same water as a violent burst of steam plus 150 degrees of heat, and heat is exactly what set the crimp flat in the first place.

Three faults, three answers

Fibre that lifts under your fingers is the ice job and it costs nothing. Move the furniture, lay three or four cubes per dent spread out rather than piled, and leave them. Blot the water with a towel when they have gone — do not rub, which mats the pile — then tease the tufts upright with your fingers or a soft brush, working in the direction the pile already lies. Then leave it alone for a day, which is the hard part: walking on it before it dries presses it straight back down.

A hard dish with a defined rim is the backing, and the honest answer is a patch. Cut a square of matching carpet from the offcut every new carpet leaves — check the wardrobe, the loft, the back of a cupboard — and match the pile direction before you cut, because a patch laid against the pile is visible from across the room. Carpet fitters call this a plug patch: a square cut with a steel rule and a sharp blade, held with double-sided carpet tape, with the pile direction aligned.

Fibre that crumbles or snaps is a carpet that has aged past treatment — usually polypropylene that has had sun, or a cheap carpet in a walkway. Pinch a tuft: if it breaks off instead of bending, there is nothing to lift. This is where you stop treating and start covering: a rug over the worn patch, furniture moved to a new arrangement, or replacement. The distinction matters because the ice method on brittle fibre makes a fuzzy hole where there was a dent.

Three rules, and the first one has ruined more carpet than wear has. Never iron a synthetic carpet. Polypropylene — most cheap carpet, and most office carpet — melts at about 165 °C, and a domestic iron's low setting is already there; the result is a shiny flat plate that cannot be repaired, only patched. Polyester is better at 260 and nylon at 220, but the heat that flattens a crimp is well below either. Do not cut a dent out. Trimming the tuft tips leaves a blunt, pale square with no protection, and wear spreads out from its edges. Do not skip the furniture cups. A cup spreads the load over three or four times the area, so the pressure drops to a quarter and the crimp survives; that is the difference between treating this once and treating it every year.

Faults next to this one